Take careful notice of vehicles fitted with I-KEY. J31 Maxima (All variants 2009MY>)-250 ST-L variant is notfitted with “I-KEY”-250 ST-L / 350 ST-S variants are notfitted with “AV C/U” (colour screen / Sat Nav)ĬONFIGURATIONK13 Micra (All variants 2010 MY >) Z51 Murano(All variants 2009MY >)-2009MY ST Muranois notfitted with “I-KEY”-2010MY> ST Muranois fitted with “I-KEY”(Look for small button on the exterior door handles -both front doors to confirm) R51 Pathfinder / D40 Navara(Spain / Thai)-The list shown right applies to all R51 & Spain build D40-For all Thailand build D40, there is only 1 changeable item “KEYLESS ENTRY”-For all D40 RX 2005 ~ 2010MY, KEYLESS ENTRY = WITHOUT Refer to the list shown right for these settings. For earlier models, there are only 4 changeable items. T31 X-TRAIL (All variants 2007MY>)-List shown right applies from July 2010 onwards. Otherwise the settings shown right apply to all J10 variants. For earlier models, PTC HEATER & DTRL does not appear on list. J10 Dualis(All variants 2008MY>)-List shown right applies from Oct 2009 onwards. (otherwise an Alarm will sound when A/T shift lever is in the “R” position. This is a new product under continuous development.
#Nissan data scan nats configure software
This app works with the same cars as our NDSI software for windows.
#Nissan data scan nats configure for android
The Nissan DataScan I for Android is intended for older Nissan and Infiniti cars equipped with a 14-pin Consult I connecter. The configuration of most current models is included on the following pages.Ĭ11 Tiida(All variants 2006MY >)-2010MY> Ti Hatch / Sedan variants with “AUTO A/C”.-Regardless of Transmission fitted, do not set “TRANSMISSION” as “A/T”. The Nissan DataScan II for Android application supports factory Nissan and Infiniti engine ECUs. If there is any doubt on what to write to the BCM, connect CONSULT to another vehicle of the same specification & utilise the “Print Screen”option & print off each configuration screen.
![nissan data scan nats configure nissan data scan nats configure](https://i.ytimg.com/vi/krTKQEVnrFM/maxresdefault.jpg)
Click this “OK”button & then the new settings will be locked into place. NOTE: Any DTCs that will not clear are not covered by this bulletin. One can change the way it displays the data about the sensors sampling rate, ranges, set audio trigger points, units, and scaling value. Compatible vehicles can be diagnosed using generic (multibrand) ELM327 interfaces. To configure a BRAND NEW BCM to a vehicle (or change any settings) –select the “Manual Configuration” option.Īll settings need to be changed to suit the current vehicle.(i) Click on the drop-down arrows (circled) to make the correct settings for each BCM function.(ii) Once any settings have been changed, click the “Next” button in the RH bottom corner of the screen.Īn “OK” button will then appear in it‟s place. When the calibration data has been written to the TCM, the message Data writing completed successfully will be displayed and Current status will indicate Complete (Figure A8). Interpreting table data The tables on this page represent lists of vehicles that are compatible with the OBD standard (EOBD or OBD2 depending on the country). NOTE:Currently the BCM is configured Manually and the VIN is not required.(i) To progress to the next screen, simply enter any letter into the first VIN box.(ii) Select “Confirm”. The next screen asks for the VIN to be entered.